CNC Shaft
Core Advantages
Aligned Bearing Seats
Finish machining controls coaxiality and circular runout to ≤0.008 mm. With bearing seats spaced along the shaft, this limits the radial departure of the working surfaces from the reference axis as the shaft rotates, and maintains the intended relationship between the separated bearing seats.
Heat-Treated Drive Material
40Cr and 42CrMo alloy steels are available with quenching and tempering. For a drive shaft subjected to repeated torque changes, the specified heat-treated condition provides the required combination of strength and toughness in the load-bearing sections.
Ground Working Surfaces
Secondary grinding produces surface roughness down to Ra 0.1 µm. On a designated journal or sliding contact area, grinding refines the turned surface where repeated contact occurs, while non-contact sections remain governed by their own drawing requirements.

Specifications and Parameters
|
Parameter Item |
Technical Index |
|
Processing Diameter Range |
φ0.8mm - φ200mm |
|
Processing Length Range |
5mm - 1500mm |
|
Dimensional Tolerance |
±0.003mm - ±0.05mm |
|
Coaxiality |
≤0.008mm (finish machining) |
|
Circular Runout |
≤0.008mm (finish machining) |
|
Surface Roughness |
Ra 0.2μm - Ra 6.3μm (can be ground to Ra 0.1μm subsequently) |
|
Processable Materials |
45#/40Cr carbon steel, 42CrMo alloy steel, 304/316L stainless steel, 6061-T6/7075-T6 aluminum alloy, H62 brass, TC4 titanium alloy, GCr15 bearing steel, etc. |
|
Surface Treatment |
Quenching, tempering, blackening, galvanizing, nickel plating, chrome plating, anodizing, plastic spraying, phosphating, etc. |
|
Processing Technology |
CNC turning, milling, drilling, tapping, knurling, slotting, grinding machine finishing, heat treatment, dynamic balance correction, etc. |
Customization
Custom CNC Shafts
Shafts are made to the released drawing and its bearing, drive and axial-location references. The route separates stock removal from final machining; when thermal processing is specified, the sequence reserves the required finishing operations for the treated workpiece.
Customizable Items
• Outside diameter: 0.8–200 mm
• Overall length: 5–1,500 mm
• Stepped, eccentric, splined or worm-shaft profile
• Keyway width, depth and axial position
• End threads and retaining-ring grooves
• Axial bores and cross-drilled holes
• Protective finish and designated untreated areas
Quality Control
- Incoming material checks include the specified grade and hardness condition. First-piece inspection verifies that the support and locating arrangement produces the drawing geometry before the same setup is used for the production run.
- Journal measurements are checked at the specified positions, and shoulder distances are measured from the drawing references. In-process sampling follows tool wear and setup changes; final working surfaces are inspected again after the last machining operation.
- Every shaft is inspected before packing for conformity and surface damage. Thread ends, groove edges and exposed journals receive particular attention, and the finished-part results remain associated with the order and drawing revision.
FAQ
Q: How long does a custom shaft sample take?
A: Custom sample development takes 10 days.
Q: What is the production lead time for custom shafts?
A: Custom production takes 10–15 days.
Q: Does a runout result also confirm dynamic balance?
A: No. Dynamic balance must be checked separately.
Q: What alignment limits apply when installing a flexible coupling?
A: Use the coupling manufacturer's offset, angular alignment and hub-spacing limits.

